Notices in the Use of Cold Roll Forming Machine

With the continuous development of China's industry, cold roll forming technology has also developed rapidly. Cold roll forming machine has become an indispensable part of some professional factories. Then, there are also some points needing attention in the use of it.

First of all, we should choose a flat table to stabilize the machine. We can pull the foot of the chassis to make the machine panel easy to observe. Plug the plug on the handheld induction head into the socket on the panel and screw it tightly. Pay attention to locating the gap.

Secondly, insert one end of the plug of the power cord into the socket on the back panel of the chassis, and the other end into the power supply socket. Make sure to use the single-phase three-wire power supply. Then turn on the POWER SW. on the back panel of the chassis and press the key of SWITCHING. When the green indicator of WARM UP is on, the machine can work. Press the "SETTING BUTTON" button and set it to the appropriate value, usually between 0.5 and 2.0 seconds.

Put the sensor head on the top of the container cover again and press the start button on the handle. At this time, the "HEATING" red indicator lights up, indicating that it is heating. Don't move the sensor head. Remove the sensor head after the "HEATING" red indicator lights out.

Later, after the "Warm UP" green light is on or the buzzer's short "beep" prompt, the sealing operation of the next container can be carried out. Check sealing quality, according to different materials, the diameter of containers and production efficiency, appropriate trimming of the "SETTING BUTTON" key, so that the sealing quality is super.