Daily Maintenance of Automated Tube Cutting Machine
After a period of use, there will be a certain degree of wear in the internal parts of automated tube cutting machine. If not maintained timely, the service life of the equipment will be reduced, and the work process will also be affected, but if it is well protected on a regular basis, it will reduce the occurrence of this phenomenon.
I. Causes of the wear of automated tube cutting machine:
We must know clearly about the maximum load of the automated tube cutting machine equipment to prevent the machinery from being damaged due to excessive load in use. In our practical application, there are many relevant personnel who operate the automated tube cutting machine but do not understand the operation procedures and mechanical performance of the machine. Therefore, it is possible to carry out wrong operation in use, resulting in the damage of the automated tube cutting machine.
The wear of automatic pipe cutting machine is caused by the improper protection work, which leads to the oil spill of bending hoop parts, resulting in a huge impact on the original operating environment and the aggravation of the wear during operation. In addition, the operating frequency of parts is constantly rising, which causes the operation failure under the influence of many factors. The load of automated tube cutting machine must be evenly accelerated to ensure the smooth operation of the machine and make the mechanism changes under a relatively stable load.
II. Routine maintenance of automated tube cutting machine:
1. Before starting the machine, carefully inspect whether all parts of the machine are normal, whether the connecting bolts are tight and reliable and whether there is leakage in the air pipe. Regularly check whether the fastening bolts of all parts are loose with a wrench.
2. Clean up the machine in time to keep the equipment clean. Please cut off the power and turn off the air source after work.
3. The parts that need lubrication must be regularly filled with lubricating oil. When replacing the cutting tool or repairing the machine, please cut off the power and hang the inspection card.
